Hawking Technologies HMPS2U Manual de usuario Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
9
Chapter 3 Basic Installation
3.1 Connecting the Hardware
1. Make sure that your USB devices are switched off and that the Server’s Power
Adapter is disconnected.
2. Connect the USB devices to the USB ports with the USB cables.
3. Connect the Server to the network with a twisted-pair category 5 cable, 10baseT
or 100baseTX.
4. Turn on the USB devices and make sure they are ready for use.
5. Connect the Power Adapter to the Server. The power indicator will light up and the
USB indicator will flash in turn. When the Link indicator lights up, the Server is
correctly connected to the network. When the USB indicator stops flashing, the
Server starts to work normally.
3.2 Assigning an IP Address to the Server
3.2.1 Preliminary
If you have a DHCP server on your network, your Server will receive an IP
address automatically. The IP address will then appear on the setup software
when it detects your print server. If your DHCP server does not give an IP address
to the Server, the Server will use the automatic private IP addressing IP:
169.254.0.0. ~ 169.254.255.255
If you are not working in a DHCP network, you need to manually set the Server’s
IP address.
3.2.2 IP Address
Unless you are assigning an IP address using DHCP, you must obtain an unused IP
address from your network administrator.
3.2.3 Methods for Setting the IP Address
You can set the IP address of your Server using one of the following methods, depending
on your network operating environment:
Automatic IP Address Assignment
Manual IP Address Assignment
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comentarios a estos manuales

Sin comentarios